Control the operation of chip drying and melt spinning to promote stable operation.

 Screw extrusion melt spinning is heated by biphenyl heat carrier. When the biphenyl heats up, it needs to be exhausted, and the exhaust should be slow to avoid taking the biphenyl out; when exhausting, it is strictly forbidden to approach the open flame and do not exhaust into the room to avoid fire and poisoning.

The temperature in this post is high, and the Department of Defense must do a good job in cooling down.

 The winding speed of the winder is very high, and it is easy to bring the hook in accidentally during operation, causing the flying hook to hurt people. Therefore, it is necessary to educate the manipulator to concentrate on manipulating and stand in a favorable and safe position to avoid flying hook injury.

When winding the wire on the waste wire roll, if there are several strands of wire wound on the roll, use one hand to hold the original tow when rewinding the wire, so as to prevent the tow from winding the hooks and causing flying hooks.

When cutting the waste wire on the waste wire roller, be sure to step on the brake device with your foot, and use the knotting knife to cut the waste wire after it stops.

 When raising and lowering the cluster frame, it is strictly forbidden to stand under the frame.

 When handling the drafting winding roll, be sure to reduce the speed or stop processing. When hooking, concentrate on hooking at the exit to prevent hooking.

 Be careful not to spill the oil. Once it spills on the ground, it should be washed in time to prevent slipping while walking.

 When the cutting machine is turned on and raises the head, the hand holding the wire head and feeding it into the cutting hook wheel, if not properly matched, it is easy to happen that the hand has not left, the console is turned on, and the hand is brought in, causing a hand cutting accident. Therefore, the operation of the cutting machine must be closely coordinated, and the machine must be turned on after the hand is removed.

 In the packing process, the main gland should be covered with the covering cloth when the machine stops, and then the main gland should be raised. Do not use the main gland wrapping cloth when raising the gland to prevent squeezing your hands.

 It is necessary to do a good job of fire prevention in fiber warehouses.