What are the precautions during the operation of the polypropylene spinning machine?

1. The transmission part of the polypropylene spinning machine should run smoothly without abnormal noise.

2. Under normal working conditions of the polypropylene spinning machine, the surface temperature rise of the gear box of the screw extruder should not exceed 30°C. The temperature rise of the metering pump gearbox should not exceed 20°C.

3. When the ambient temperature of the polypropylene spinning machine is lower than 28°C, the average temperature of the front and back surfaces of the spinning box insulation layer should not be greater than 65°C.

4. No leakage is allowed at the pipe connection of the polypropylene spinning machine.

5. The wind speed of the blowing device should be stable, and there should be no violent fluttering or twining of the silk. The wind speed difference rate of the single spinning position on the same level in the ring blowing device should not be greater than 15, and the wind speed difference rate of the single spinning position on the same level in the side blowing device should not be greater than 20.

6. The tow channel and the contact part of the tow should be smooth and free of wire.

7. The air tightness test of the biphenyl pipeline shall be carried out according to the value specified in the technical document, and no leakage shall be allowed.

8. The spinning box shall be manufactured, tested and accepted according to GB 150, and shall be supervised by TSG R0004--2009.

9. The temperature difference at the fixed temperature measuring point of the spinning box heated by the heat medium should not exceed 2°C.

10. The temperature difference between the fixed temperature measuring points of the electrically heated spinning head should not exceed 3°C.

11. The temperature control accuracy of each zone of the screw extruder should be ±2℃.

12. The melt pressure control accuracy of the screw extruder should be ±0.3 MPa.

13. The metering pump should meet the regulations of FZ/T 92026.

14. The spinneret should meet the regulations of FZ/T 92038.

15. Electrical equipment and lines are well insulated, with insulation resistance ≥ 1 Mi2.

16. The protective grounding of the metal shell is reliable, and the grounding resistance is less than or equal to 0.1 Q.

17. The electrical components should be able to withstand the withstand voltage test lasting 1 min. The test voltage is ≥1 500 V. The components that cannot withstand the above-mentioned high voltage must be disconnected during the test.

18. The painting of polypropylene spinning machine should comply with the regulations of FZ/T 90074.